Table of Contents
Advertisement
Configuring Quality of Service
Configuring QoS - General
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
Cisco Small Business 200 Series Smart Switch Administration Guide
To map DSCP to queues:
Click Quality of Service > General > DSCP to Queue. The DSCP to Queue page
is displayed.
The DSCP to Queue page contains Ingress DSCP. It displays the DSCP value in
the incoming packet and its associated class.
Select the Output Queue (traffic forwarding queue) to which the DSCP value is
mapped.
Click Apply. The Running Configuration file is updated.
Configuring Bandwidth
The Bandwidth page enables users to define two values, Ingress Rate Limit and
Egress Shaping Rate, which determine how much traffic the system can receive
and send.
The ingress rate limit is the number of bits per second that can be received from
the ingress interface. Excess bandwidth above this limit is discarded.
The following values are entered for egress shaping:
•
Committed Information Rate (CIR) sets the average maximum amount of
data allowed to be sent on the egress interface, measured in bits per
second
•
Committed Burst Size (CBS) is the burst of data that is allowed to be sent,
even though it is above the CIR. This is defined in number of bytes of data.
To enter bandwidth limitation:
Click Quality of Service > General > Bandwidth. The Bandwidth page is
displayed.
The Bandwidth page displays bandwidth information for each interface.
The % column is the ingress rate limit for the port divided by the total port
bandwidth.
Select an interface, and click Edit. The Edit Bandwidth page is displayed.
Select the Port or LAG interface.
20
279
Hide quick links:
Advertisement
Table of Contents
