Managing System Files
Upgrade/Backup Firmware/Language
STEP 4
Cisco Small Business 200 Series Smart Switch Administration Guide
Select one of the following actions:
•
Upgrade Save Action—Specifies that the file type on the switch is to be
replaced with a new version of that file type located on a TFTP server.
•
Backup Save Action—Specifies that a copy of the file type is to be saved to
a file on another device.
Enter the following fields:
•
File Type—Select the destination file type. Only valid file types are shown.
(The file types are described in the
•
TFTP Server Definition—Select whether to specify the TFTP server by IP
address or domain name.
•
IP Version—Select whether an IPv4 or an IPv6 address is used.
•
IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The
options are:
-
Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
-
Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
•
Link Local Interface—Select the link local interface (if IPv6 is used) from the
list.
•
TFTP Server IP Address/Name—Enter the IP address or the domain name
of the TFTP server.
•
(For Upgrade) Source File Name—Enter the name of the source file.
•
(For Backup) Destination File Name—Enter the name of the backup file.
If you selected via HTTP/HTTPS, you can only Upgrade. Enter the parameters as
described in this step.
•
File Type—Select the configuration file type. Only valid file types can be
selected. (The file types are described in the
The following file types can be upgraded:
-
Firmware Image—Select this to upgrade the firmware image.
-
Language—Select this to upgrade the language file.
Files and File Types
Files and File Types
4
section).
section).
34