Configuring Login Authentication - Cisco Catalyst 8540 MSR Configuration Manual

Atm switch router software configuration guide

Hide thumbs Also See for Catalyst 8540 MSR:

Table of Contents

Configuring System Management Functions

logging monitor level

logging trap level

logging source-interface type

Configuring Login Authentication

To enable TACACS+ authentication for logins, perform the following steps, beginning in global

configuration mode:

line [aux | console | vty] line-number

[ending-line-number]

Limits messages logged to the terminal lines

(monitors) based on severity, use the logging monitor

global configuration command. This command limits

the logging messages displayed on terminal lines other

than the console line to messages with a level at or

above level. The no logging monitor command

disables logging to terminal lines other than the

console line.

Controls logging of error messages, use the logging on

global configuration command. This command enables

or disables message logging to all destinations except

the console terminal. The no logging on command

enables logging to the console terminal only.

Limits messages logged to the syslog servers based on

severity, use the logging trap global configuration

command. The command limits the logging of error

messages sent to syslog servers to only those messages

at the specified level. The no logging trap command

disables logging to syslog servers.

Specifies the interface for source address in logging

transactions.

Selects the line to configure.

Configures login authentication.

ATM Switch Router Software Configuration Guide

System Management Tasks

Catalyst 8510 msr Lightstream 1010