Debug Ip Verify Source Packet - Cisco Catalyst 3750 Command Reference Manual
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Software configuration manual (926 pages) ,
- Hardware installation manual (231 pages)
Table of Contents
Advertisement
Appendix B
Catalyst 3750 Switch Debug Commands
debug ip verify source packet
Use the debug ip verify source packet privileged EXEC command to enable debugging of IP source
guard. Use the no form of this command to disable debugging.
This command is available only if your switch is running the enhanced multilayer image (EMI).
Syntax Description
This command has no arguments or keywords.
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.2(20)SE
Usage Guidelines
The undebug ip verify source packet command is the same as the no debug ip verify source packet
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
Command
show debugging
78-16181-03
debug ip verify source packet
no debug ip verify source packet
Modification
This command was introduced.
Description
Displays information about the types of debugging that are
enabled. For syntax information, select Cisco IOS Release 12.2
Configuration Guides and Command References > Cisco IOS
Configuration Fundamentals Configuration Guide, Release
12.2 > System Management > Troubleshooting and Fault
Management.
Catalyst 3750 Switch Command Reference
debug ip verify source packet
B-13
Advertisement
Table of Contents
