Cisco Catalyst 3750 Command Reference Manual page 521

Hide thumbs Also See for Catalyst 3750:

Table of Contents

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

Though visible in the command-line help strings, the cpu [threshold] keyword is not supported. The

snmp-server enable informs global configuration command is not supported. To enable the sending of

SNMP inform notifications, use the snmp-server enable traps global configuration command

combined with the snmp-server host host-addr informs global configuration command.

The sending of SNMP traps is disabled.

Command Modes

Global configuration

Command History

Usage Guidelines

Specify the host (NMS) that receives the traps by using the snmp-server host global configuration

command. If no trap types are specified, all trap types are sent.

When supported, use the snmp-server enable traps command to enable sending of traps or informs.

Informs are not supported in SNMPv1.

To enable more than one type of trap, you must enter a separate snmp-server enable traps command

for each trap type.

This example shows how to send VTP traps to the NMS:

Switch(config)# snmp-server enable traps vtp

You can verify your setting by entering the show vtp status or the show running-config privileged

EXEC command.

(Optional) Enable SNMP VLAN-deleted traps.

(Optional) Enable VLAN Trunking Protocol (VTP) traps.

Modification

This command was introduced.

The bgp, copy-config, envmon, flash, port-security, stpx, syslog,

vlancreate, and vlandelete keywords were added.

The ipmulticast, msdp, ospf [cisco-specific | errors | lsa | rate-limit |

retransmit | state-change], pim [invalid-pim-message | neighbor-change

| rp-mapping-change], and tty keywords were added.

The storm-control trap-rate value keywords were added.

snmp-server enable traps

Catalyst 3750 Switch Command Reference