Debug Mac-Notification - Cisco Catalyst 3750 Command Reference Manual

Hide thumbs Also See for Catalyst 3750:

Table of Contents

debug mac-notification

Use the debug mac-notification privileged EXEC command to enable debugging of MAC notification

events. Use the no form of this command to disable debugging.

Syntax Description

This command has no arguments or keywords.

Debugging is disabled.

Command Modes

Privileged EXEC

Command History

Usage Guidelines

The undebug mac-notification command is the same as the no debug mac-notification command.

When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack

member, you can start a session from the stack master by using the session switch-number privileged

EXEC command. Then enter the debug command at the command-line prompt of the stack member. You

also can use the remote command stack-member-number LINE privileged EXEC command on the stack

master switch to enable debugging on a member switch without first starting a session.

Related Commands

show debugging

address-table

notification

Catalyst 3750 Switch Command Reference

debug mac-notification

no debug mac-notification

Modification

This command was introduced.

Displays information about the types of debugging that are enabled. For

syntax information, select Cisco IOS Release 12.2 Configuration Guides

and Command References > Cisco IOS Configuration Fundamentals

Configuration Guide, Release 12.2 > System Management >

Troubleshooting and Fault Management.

Displays the MAC address notification information for all interfaces or the

specified interface.

Catalyst 3750 Switch Debug Commands