Cisco Catalyst 3750 Command Reference Manual page 780

Hide thumbs Also See for Catalyst 3750:

Table of Contents

debug spanning-tree mstp

Usage Guidelines

The undebug spanning-tree mstp command is the same as the no debug spanning-tree mstp

When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack

member, you can start a session from the stack master by using the session switch-number privileged

EXEC command. Then enter the debug command at the command-line prompt of the stack member. You

also can use the remote command stack-member-number LINE privileged EXEC command on the stack

master switch to enable debugging on a member switch without first starting a session.

Related Commands

show debugging

show spanning-tree

Catalyst 3750 Switch Command Reference

Displays information about the types of debugging that are enabled. For

syntax information, select Cisco IOS Release 12.2 Configuration Guides

and Command References > Cisco IOS Configuration Fundamentals

Configuration Guide, Release 12.2 > System Management >

Troubleshooting and Fault Management.

Displays spanning-tree state information.

Catalyst 3750 Switch Debug Commands