Cisco Catalyst 3750-X Command Reference Manual page 1158

Cisco ios release 15.2(1)e and later

Hide thumbs Also See for Catalyst 3750-X:

Table of Contents

debug spanning-tree switch

Usage Guidelines

The undebug spanning-tree switch command is the same as the no debug spanning-tree switch

When you enable debugging on a switch stack, it is enabled only on the stack master. To enable

debugging on a stack member, you can start a session from the stack master by using the session

switch-number privileged EXEC command. Then enter the debug command at the command-line

prompt of the stack member. You also can use the remote command stack-member-number LINE

privileged EXEC command on the stack master switch to enable debugging on a member switch without

first starting a session.

Related Commands

show debugging

show spanning-tree

Catalyst 3750-X and 3560-X Switch Command Reference

Displays information about the types of debugging that are enabled.

Displays spanning-tree state information.

Catalyst 3750-X and 3560-X Switch Debug Commands

Catalyst 3560-x