Cisco Catalyst 3750-X Command Reference Manual page 1166

Cisco ios release 15.2(1)e and later

Hide thumbs Also See for Catalyst 3750-X:

Table of Contents

debug sw-vlan vtp

Usage Guidelines

The undebug sw-vlan vtp command is the same as the no debug sw-vlan vtp command.

When you enable debugging on a switch stack, it is enabled only on the stack master. To enable

debugging on a stack member, you can start a session from the stack master by using the session

switch-number privileged EXEC command. Then enter the debug command at the command-line

prompt of the stack member. You also can use the remote command stack-member-number LINE

privileged EXEC command on the stack master switch to enable debugging on a member switch without

first starting a session.

If no further parameters are entered after the pruning keyword, VTP pruning debugging messages

appear. They are generated by the VTP_PRUNING_LOG_NOTICE, VTP_PRUNING_LOG_INFO,

VTP_PRUNING_LOG_DEBUG, VTP_PRUNING_LOG_ALERT, and

VTP_PRUNING_LOG_WARNING macros in the VTP pruning code.

Related Commands

show debugging

Catalyst 3750-X and 3560-X Switch Command Reference

Displays information about the types of debugging that are enabled.

Displays general information about VTP management domain, status, and

Catalyst 3750-X and 3560-X Switch Debug Commands

Catalyst 3560-x