Show Sdm Prefer - Cisco Catalyst 3750-X Command Reference Manual
Cisco ios release 15.2(1)e and later
Hide thumbs
Also See for Catalyst 3750-X:
- Software configuration manual (1438 pages) ,
- Message manual (150 pages) ,
- Getting started manual (22 pages)
Table of Contents
Advertisement
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
show sdm prefer
To display information about the Switch Database Management (SDM) templates that can be used to
maximize system resources for a particular feature, use the show sdm prefer command in privileged
EXEC mode. To display the template in use, use the command without a keyword.
show sdm prefer [access | default | dual-ipv4-and-ipv6 {default | routing | vlan} |
indirect-ipv4-and-ipv6- routing | routing | vlan]
Note
Although visible in the command-line help, the ipe keyword is not supported.
Syntax Description
access
default
dual-ipv4-and-ip
v6 {default |
routing | vlan)
indirect-ipv4-and
-ipv6-routing
routing
vlan
Command Modes
Privileged EXEC
Command History
Release
12.2(53)SE2
12.2(58)SE
Usage Guidelines
When you change the SDM template by using the sdm prefer global configuration command, you must
reload the switch for the configuration to take effect. If you enter the show sdm prefer command before
you enter the reload privileged EXEC command, the show sdm prefer command shows the template
currently in use and the template that will become active after a reload.
The numbers displayed for each template represent an approximate maximum number for each feature
resource. The actual number might vary, depending on the actual number of other features configured.
OL-29704-01
(Optional) Display the template that maximizes system resources for ACLs.
(Optional) Display the template that balances system resources among features.
(Optional) Display the dual templates that support both IPv4 and IPv6.
default—Display the default dual template configuration.
•
routing—Display the routing dual template configuration.
•
This keyword is not supported on switches running the LAN base feature set.
Note
vlan—Display the VLAN dual template configuration.
•
(Optional) Displays the indirect IPv4 and IPv6 routing template that provides
more entries for IPv4 and IPv6 summary or indirect routes. This keyword is not
supported on switches running the LAN base feature set.
(Optional) Display the template that maximizes system resources for routing. This
keyword is not supported on switches running the LAN base feature set.
(Optional) Display the template that maximizes system resources for Layer 2
VLANs.
Modification
This command was introduced.
The indirect-ipv4-and-ipv6-routing keywords were added.
Catalyst 3750-X and 3560-X Switch Command Reference
show sdm prefer
2-795
Advertisement
Table of Contents
