Radius-Server Dead-Criteria - Cisco Catalyst 2960 Command Reference Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages)
Table of Contents
Advertisement
Chapter 2
Catalyst 2960 Switch Cisco IOS Commands
radius-server dead-criteria
Use the radius-server dead-criteria global configuration command to configure the conditions that
determine when a RADIUS server is considered unavailable or dead. Use the no form of this command
to return to the default settings.
Syntax Description
time seconds (Optional) Set the time in seconds during which the switch does not need to get a valid
tries number
Defaults
The switch dynamically determines the seconds value that is from 10 to 60 seconds.
The switch dynamically determines the tries value that is from 10 to 100.
Command Modes
Global configuration
Command History
Release
12.2(25)SEE
Usage Guidelines
We recommend that you configure the seconds and number parameters as follows:
•
•
•
•
Examples
This example shows how to configure 60 as the time and 10 as the number of tries, the conditions that
determine when a RADIUS server is considered unavailable
Switch(config)# radius-server dead-criteria time 60 tries 10
You can verify your settings by entering the show running-config privileged EXEC command.
OL-8604-04
radius-server dead-criteria [time seconds [tries number] | tries number]
no radius-server dead-criteria [time seconds [tries number] | tries number]
response from the RADIUS server. The range is from 1 to 120 seconds.
(Optional) Set the number of times that the switch does not get a valid response from
the RADIUS server before the server is considered unavailable. The range is from 1 to
100.
Modification
This command was introduced.
Use the radius-server timeout seconds global configuration command to specify the time in
seconds during which the switch waits for a RADIUS server to respond before the IEEE 802.1x
authentication times out. The switch dynamically determines the default seconds value that is from
10 to 60 seconds.
Use the radius-server retransmit retries global configuration command to specify the number of
times the switch tries to reach the radius servers before considering the servers to be unavailable.
The switch dynamically determines the default tries value that is from 10 to 100.
The seconds parameter is less than or equal to the number of retransmission attempts times the time
in seconds before the IEEE 802.1x authentication times out.
The tries parameter should be the same as the number of retransmission attempts.
radius-server dead-criteria
Catalyst 2960 Switch Command Reference
2-273
Advertisement
Table of Contents
