Chapter 1 Using The Command-Line Interface; Cli Command Modes - Cisco Catalyst 2960 Command Reference Manual

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Using the Command-Line Interface

The Catalyst 2960 switch is supported by Cisco IOS software. This chapter describes how to use the

switch command-line interface (CLI) to configure software features.

In this document, IP refers to IP version 4 (IPv4).

This section describes the CLI command mode structure. Command modes support specific Cisco IOS

commands. For example, the interface interface-id command only works when entered in global

configuration mode.

These are the main command modes for the switch:

For a complete description of the commands that support these features, see

2960 Switch Cisco IOS Commands."

For information on the bootloader commands, see

For information on the debug commands, see

Debug Commands."

For information on the show platform commands, see

Show Platform Commands."

For more information on Cisco IOS Release 12.2, see the Cisco IOS Release 12.2 Command

For task-oriented configuration steps, see the software configuration guide for this release.

Privileged EXEC

Global configuration

Interface configuration

VLAN configuration

Line configuration

C H A P T E R

Appendix A, "Catalyst 2960 Switch Bootloader

Appendix B, "Catalyst 2960 Switch

Appendix C, "Catalyst 2960 Switch

Catalyst 2960 Switch Command Reference

Chapter 2, "Catalyst