Cluster Enable - Cisco Catalyst 2960 Command Reference Manual

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Catalyst 2960 Switch Cisco IOS Commands

cluster enable

Use the cluster enable global configuration command on a command-capable switch to enable it as the

cluster command switch, assign a cluster name, and to optionally assign a member number to it. Use the

no form of the command to remove all members and to make the cluster command switch a candidate

Syntax Description

command-switch-member-number

The switch is not a cluster command switch.

No cluster name is defined.

The member number is 0 when the switch is the cluster command switch.

Command Modes

Global configuration

Command History

Usage Guidelines

Enter this command on any command-capable switch that is not part of any cluster. This command fails

if a device is already configured as a member of the cluster.

You must name the cluster when you enable the cluster command switch. If the switch is already

configured as the cluster command switch, this command changes the cluster name if it is different from

the previous cluster name.

This example shows how to enable the cluster command switch, name the cluster, and set the cluster

command switch member number to 4.

Switch(config)# cluster enable Engineering-IDF4 4

You can verify your setting by entering the show cluster privileged EXEC command on the cluster

command switch.

Related Commands

show cluster

cluster enable name [command-switch-member-number]

no cluster enable

Modification

This command was introduced.

Displays the cluster status and a summary of the cluster to which the switch belongs.

Name of the cluster up to 31 characters. Valid characters include

only alphanumerics, dashes, and underscores.

(Optional) Assign a member number to the cluster command

switch of the cluster. The range is 0 to 15.

Catalyst 2960 Switch Command Reference

cluster enable