Table of Contents
Advertisement
02 is the total count of characters to be replaced, plus the replacement characters (0 is replaced by CR, so total char-
acters = 2)
30 is the hex value for 0
0D is the hex value for a CR (the character that will replace the 0)
F1 is the "Send all characters" command
0D is the hex value for a CR
The data is output as:
1234
5678
ABC
<CR>
Stop replacing characters
E5 Terminates character replacement. Syntax = E5.
Compare characters
FE Compare the character in the current cursor position to the character "xx." If characters are equal, move the cursor
forward one position. Syntax = FExx where xx stands for the comparison character's hex value for its ASCII code.
Refer to the
ASCII Conversion Chart (Code Page 1252),
Compare string
B2 Compare the string in the input message to the string "s." If the strings are equal, move the cursor forward past the end
of the string. Syntax = B2nnnnS where nnnn is the string length (up to 9999), and S consists of the ASCII hex value
of each character in the match string. For example, B2000454657374 will compare the string at the current cursor
position with the 4 character string "Test."
Refer to the
ASCII Conversion Chart (Code Page 1252),
Check for a number
EC Check to make sure there is an ASCII number at the current cursor position. The format is aborted if the character is
not numeric.
EC Example: Only output the data if the bar code begins with a number
If you will only accept data from bar codes that begin with a number, you can use EC to check for the number.
Command string: ECF10D
EC is the "Check for a number" command
F1 is the "Send all characters" command
0D is the hex value for a CR
If this bar code is read,
If this bar code is read:
1234AB
<CR>
Check for non-numeric character
ED Check to make sure there is a non-numeric ASCII character at the current cursor position. The format is aborted if the
character is numeric.
ED Example: Only output the data if the bar code begins with a letter
If you will only accept data from bar codes that begin with a letter, you can use ED to check for the number.
Command string: EDF10D
ED is the "Check for a non-numeric character" command
8 - 10
beginning on page A-3 for decimal, hex and character codes.
beginning on page A-3 for decimal, hex and character codes.
the format fails.
the data is output as:
- Quick Links:
- Configuring the 2700
Hide quick links:
Advertisement
Table of Contents
