S59P(23PsF)
Record at 50 fps
Play back at
23PsF
24 frames playback/50 frames recorded = 0.48 times normal speed
Operation during slow and quick motion
shooting
During slow and quick motion shooting, input
data is stored in the memory of the HKSR-9002.
Transfer of the data to tape starts when a specified
amount of data has been stored. Therefore, the
tape does not run for a short time after recording
starts. The tape starts running when data transfer
from the memory starts, and stops running when
the specified amount of data has been transferred.
Recording proceeds by repeating this series of
operations. You can check the amount of data
stored in the memory of the HKSR-9002 with the
numeric value and bar graph shown in the MEM:
area at the bottom of the control panel display.
Notes
• During recording, data transfer to the tape starts when
you press the STOP button or PAUSE button to stop or
temporarily stop the recording. The tally indicator on
the rear side of this unit flashes four times per second
during data transfer. Be sure not to power off this unit
until the data transfer to the tape is complete.
• Tape recording is not performed until the amount of
data stored in the memory exceeds the specified value.
• Input data is not recorded while the bar graph shows
0%.
Target Frame Frequencies and Signal Formats
The following table shows the combinations of
target frame frequencies and signals formats that
are required for SR Motion shooting.
1 second recorded
1 second played back
Playback of tapes recorded with SR Motion
When you play a tape that was recorded with SR
Motion, the FPS value in SR Motion recording is
shown in the playback frequency position of the
PB line.
Operation Flow
The operation flow is shown below.
Set the target frame frequency (playback
Select the system signal format to use
Set the number of frames to shoot
50 frames in total
24 frames in total
FPS value
timecode)
r
during shooting
r
Set SELECT FPS to ON
r
r
Shoot the scene
r
Review
Overview
101