Table of Contents
Advertisement
Cursor (flashing)
On a page with two or more setting items,
pressing the SET button moves the cursor to
the next item.
Cursor
2
Move the cursor to the item to be set,
then change the setting by turning the
MENU SEL/ENTER dial.
Note
Camera menu operations on the viewfinder screen
cannot be performed while the subdisplay is in data
modification mode.
To confirm a change
Do one of the following:
• Press the PAGE button.
• Exit data modification mode by pressing the
MENU SEL/ENTER dial (the cursor and
question mark disappear).
• Terminate the subdisplay operation by pressing
the VF MENU/DISPLAY button.
To cancel a change
Press the CANCEL/STATUS button before
confirming the change.
The ? mark disappears, and the original setting is
restored.
To terminate subdisplay operation
Press the VF MENU/DISPLAY button.
Shutter Settings
The electronic shutter settings of the unit can be
displayed and adjusted as exposure time values,
or as shutter angle values, as with a film camera.
There are two adjustment modes for angles: Step
mode and Continuous mode.
Step mode (STEP)
You can register and select up to eight frequently
Question mark
used values as step shutter values.
Factory-set values are as follows:
Actual shutter speeds vary according to the frame
frequency and frame rate of the selected video
format. The shutter step values can be changed
and reregistered on the <SHUTTER ASSIGN>
page of the Camera >USER (OPERATION)
menu or the <SHUTTER> page of the Camera
>USER (PAINT) menu.
Continuous mode (CONTINUOUS)
This mode allows you to change shutter values
continuously over the range from 360.0 to 4.3
degrees.
To obtain a continuous shutter value quickly,
select a value close to the one you want in Step
mode, and then switch to Continuous mode to
make the final selection.
When operating from a remote control unit connected to
the REMOTE connector, you can control the shutter with
the STEP (shutter step operation) or CONTINUOUS
(continuous operation) functions. There is no need to set
ECS to ON on this unit. However, an upgrade is required
to display shutter values correctly on the remote control
unit.
For details, consult a Sony representative.
Shutter settings page
To select a shutter value in Step mode
In Step mode you can select a step shutter value
(one of up to eight registered values) as follows:
STEP No.
Shutter angle
1
216.0°
2
180.0°
3
172.8°
4
150.0°
5
144.0°
6
90.0°
7
45.0°
8
22.5°
Note
1
2
a)
4
a) Appears only when the optional HKSR-9002
is installed.
Basic Settings with the Subdisplay
3
a)
5
45
Advertisement
Table of Contents
