Table of Contents
Advertisement
Installing the Cisco ASR 1004 Router in a Rack
When handling the chassis, always follow proper lifting practices. See the
section on page
Inner clearance (the width between the inner sides of the two posts or rails) must be at least 19 inches
Note
(48.26cm). The height of the chassis is 6.95 inches (17.653 cm). Airflow through the chassis is from
front to back.
Note
Make sure the rack is stabilized.
Step 1
(Optional) Install a shelf in the rack to support the Cisco ASR 1004 Router. If you are using a shelf then
raise the chassis to the level of the shelf. Let the bottom of the chassis rest on the brackets, but continue
to support the chassis.Using two people, lift the chassis into the rack using the side handles and grasping
underneath the power supply bays.
Position the chassis until the rack-mounting flanges are flush against the mounting rails on the rack.
Step 2
Use the third hole up from the bottom of the rack-mount bracket and the third hole down from the top
Note
of the rack-mount bracket.
Hold the chassis in position against the mounting rails while the second person finger-tightens a screw
Step 3
to the rack rails on each side of the chassis.
rack-mount brackets on the Cisco ASR 1004 Router.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
7-16
5-23.
Chapter 7
Cisco ASR 1004 Router Overview and Installation
Figure 7-11
shows the rear rack-mount brackets and the front
"Chassis-Lifting Guidelines"
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router