Table of Contents
Advertisement
Chapter 14
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing the Cisco ASR 1001 Router Power Supplies
Installing the AC Power Supply into Cisco ASR 1001 Router
The Cisco ASR 1001 Router has two AC power supplies at the rear of the chassis. The input receptacle
is an IEC60320 C14 type of filtered AC Inlet. The current rating on the connector is 10 A.
Figure 14-76
shows the ASR 1001 Router AC power supply.
Figure 14-76
Cisco ASR 1001 Router AC Power Supply
0
1
To connect an AC-input power supply to the Cisco ASR 1001 Router, follow these steps:
There are two power supplies installed. At the rear of the chassis, check whether the power switch on
Step 1
the chassis is in the Standby position.
Do not install the Cisco ASR 1001 Router power supplies without the top cover on the Cisco ASR 1001
Warning
chassis.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
14-103
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router