Table of Contents
Advertisement
Site Planning
Rack-Mounting Guidelines
This section describes guidelines on rack-mounting.
Precautions for Rack-Mounting
The following rack-mount guidelines are provided to ensure your safety:
•
•
•
•
•
•
General Rack Selection Guidelines
Cisco 1000 Series Routers can be mounted in most two-post or four-post, 19-in. equipment racks that
comply with the Electronics Industries Association (EIA) standard for equipment racks (EIA-310-D
19-in.). The rack must have at least two posts with mounting flanges to mount the chassis.
When mounting a chassis in any type of rack equipment, ensure that the inlet air to the chassis does not
Caution
exceed 131°F (55°C).
The distance between the center lines of the mounting holes on the two mounting posts must be 18.31
in. ± 0.06 in. (46.50 cm ± 0.15 cm). The rack-mounting hardware included with the chassis is suitable
for most 19-in. equipment racks.
Consider installing the Cisco 1000 Series Router in a rack with the following features:
•
•
•
•
The Cisco 1000 Series Router should not be installed in an enclosed rack because the chassis requires
Note
an unobstructed flow of cooling air to maintain acceptable operating temperatures for its internal
components. Installing the router in any type of enclosed rack—even with the front and back doors
removed—could disrupt the air flow, trap heat next to the chassis, and cause an overtemperature
condition inside the router. If you use an enclosed rack, make certain that there are air vents on all sides
of the rack and there is proper ventilation.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
5-16
Do not move large racks by yourself. Due to the height and weight of a rack, a minimum of two
people are required to accomplish this task.
Ensure that the rack is level and stable before extending a component from the rack.
Ensure that proper airflow is provided to components in the rack.
Do not step or stand on any component or system when servicing other systems or components in a
rack.
When mounting the Cisco 1000 Series Router in a partially filled rack, load the rack from the bottom
to the top with the heaviest component at the bottom of the rack.
If the rack is provided with stabilizing devices, then install the stabilizers before mounting or
servicing the unit in the rack.
NEBS compliant, 19-in. (48.3 cm) wide rack.
EIA or ETSI hole patterns in the mounting rails. Required mounting hardware is shipped with the
Cisco 1000 Series Router. If the rack that you plan to install the system in has metric-threaded rails,
you must provide your own metric mounting hardware.
Perforated top and open bottom for ventilation to prevent overheating.
Leveling feet for stability.
Chapter 5
Preparing Your Site for Installation
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router