hit counter script

Cisco ASR 1000 series Hardware Installation Manual page 525

Aggregation services routers
Table of Contents

Advertisement

Chapter 14
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Replace the AC power supply within five minutes.
Step 7
This completes the procedure for removing the AC power supply from the Cisco ASR 1013 chassis.
Replacing the AC Power Supply in Cisco ASR 1013 Router
This section provides information about installing an AC power supply in the Cisco ASR 1013 Router.
Warning
Never install an AC power module and a DC power module in the same chassis. Statement 1050
Insert an AC power supply in power supply slot 0 or power supply slot 1 until it is fully seated.
Step 1
Tighten the captive screws.
Step 2
Insert the AC power cable.
Step 3
Plug the power supply cable into the power source.
Step 4
Turn the power supply Standby switch to the On (|) position.
Step 5
This completes the procedure for installing the AC power supply in the Cisco ASR 1013 Router.
Removing and Replacing a DC Power Supply in Cisco ASR 1013 Router
This section provides information about removing and installing a DC power supply in the Cisco
ASR 1013 Router.
When you install the unit, the ground connection must always be made first and disconnected last.
Warning
Statement 1046
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Statement 1003
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
OL-13208-11
Removing and Replacing the Cisco ASR 1013 Router Power Supplies
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
14-95

Advertisement

Table of Contents
loading

This manual is also suitable for:

Asr 1000 series

Table of Contents