Table of Contents
Advertisement
Chapter 13
Cisco ASR 1000 Series Routers Power Up and Initial Configuration
R0
R1
F0
F1
P0
P1
P2
P3
Slot
--------- ------------------- ---------------------------------------
0
1
2
3
4
5
R0
R1
F0
F1
MCP_CAP_13RU#
If the LEDs indicate a power problem or the power supply state is ps, fail, then contact a customer
service representatives for assistance or additional instructions.
Powering Up the Cisco ASR 1000 Series Routers
Make certain that all card slots and compartments are closed off. Install blank faceplates on any empty
slots. Always have power supply slots filled. If you leave a power supply slot uncovered, then you risk
exposure to hazardous voltages on the power pins on the midplane.
After installing your Cisco ASR 1000 Series Routers and connecting cables, start the router.
Warning
Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place. Statement
1029
There is no cover on the Cisco ASR 1002 Router and the Cisco ASR 1002-X Router DC power supply
Note
terminal block; therefore, Statement 1029 does not apply to the Cisco ASR 1002 router.
You are now ready to power on the system for the first time. Follow these steps.
Before you power on, make sure that:
Step 1
a.
b.
c.
OL-13208-11
ASR1000-RP2
ASR1000-RP2
ASR1000-ESP40
ASR1000-ESP40
ASR1013-PWR-AC
ASR1013-PWR-AC
ASR1013-PWR-AC
ASR1013-PWR-AC
CPLD Version
00200800
00200800
09111601
00200800
00200800
09111601
10021901
10021901
1001270D
1001270D
The AC cord is plugged into the AC power inlet.
All cables are connected.
Your computer is powered up and connected.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
ok, active
22:56:46
ok, standby
22:56:46
ok, active
22:56:46
ok, standby
22:56:46
ps, fail
22:55:56
ok
22:55:56
ok
22:55:56
ps, fail
22:55:56
Firmware Version
15.0(1r)S
15.0(1r)S
15.0(1r)S
15.0(1r)S
15.0(1r)S
15.0(1r)S
15.0(1r)S
15.0(1r)S
15.0(1r)S
15.0(1r)S
Powering Up the Cisco ASR 1000 Series Routers
13-3
Advertisement
Chapters
Table of Contents
Troubleshooting
