Table of Contents
Advertisement
<OUTPUT FORMAT> page
CURRENT
Display the current format.
SCAN
Select the scan mode: PROGRESSIVE or
INTERLACE.
FRAME
Select the frame rate. When you select
INTERLACE for the scan mode, select 29.97 to
specify 59.94I or select 25 to specify 50I.
SIGNAL
Select the signal format.
The compression ratio of 4:4:4 HQ is
SQ.
When the settings are completed, move the cursor
to SET FORMAT and press the MENU SEL/
ENTER dial.
The format is changed, and the new format is
displayed on the CURRENT line.
The message "UNSUPPORTED FORMAT"
appears for three seconds if the settings change is
rejected.
SELECT FPS
When the optional HKSR-9002 is installed, set
this to ON to use the Select FPS function (see
page 107).
The selected format appears on the NEXT line.
When the settings are completed, move the cursor
to SET FORMAT and press the MENU SEL/
ENTER dial.
The format changes, and the new format appears
on the CURRENT line.
Notes
• If you select an invalid format combination (e.g., 60P
and 4:4:4), SET FORMAT appears in parentheses, and
the format cannot be changed.
• The message "UNSUPPORTED FORMAT" appears
for 3 seconds if the unit is unable to change the settings
after the above operations.
80
Detailed Video Format Settings
Setting the Video Format in the
VTR Menu
Use FORMAT or OTHERS in the SYSTEM
Setup menu to select the system signal format.
Notes
• The tape formats supported by this unit may differ
from those supported by other VTRs.
Before selecting the tape format, be sure to read
"About Recording/Playback Formats" (page 210).
• If a cassette is loaded in the unit, be sure to eject it
before starting the following procedure.
For details on menu operations, see "VTR Menu
Operations" (page 171).
To set with FORMAT
1
/
of 4:4:4
2
1
Press the menu selection button
"SYSTEM" on the control panel.
The SYSTEM Setup menu appears.
2
Turn the SELECT/ENTER dial to
move the cursor to FORMAT, and then
press the dial.
A submenu window appears.
Advertisement
Table of Contents
