Configuration Examples For Configuring Object Tracking - Cisco NCS 5000 Series Manual
System management configuration guide for cisco ncs 5000 series
routers
Hide thumbs
Also See for NCS 5000 Series:
- Hardware installation manual (72 pages) ,
- Manual (186 pages)
Table of Contents
Advertisement
Implementing Object Tracking
Command or Action
Configuration Examples for Configuring Object Tracking
Tracking Whether the Interface Is Up or Down: Example
track connection100
type list boolean and
interface service-ipsec 23
line-protocol track connection100
!
Tracking the Line Protocol State of an Interface: Example
In this example, traffic arrives from interface service-ipsec1 and exits through interface GigabitEthernet
0/0/0/3:
track IPSec1
type line-protocol state
interface service-ipsec 1
ipv4 address 70.0.0.1 255.255.255.0
profile vrf1_profile_ipsec
line-protocol track IPSec1
tunnel source 80.0.0.1
tunnel destination 80.0.0.2
service-location preferred-active 0/0/1
!
Displaying the Line Protocol State of an Interface: Example
This example displays the output from the show track command after performing the previous example:
RP/0/RP0/CPU0:router# show run track
Track IPSec1
Interface GigabitEthernet0_0_0_3 line-protocol
!
object object3 not
delay up 10
!
interface gigabitethernet0/0/0/3
!
Line protocol is UP
1 change, last change 10:37:32 UTC Thu Sep 20 2007
Tracked by:
service-ipsec1
!
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
Configuration Examples for Configuring Object Tracking
Purpose
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
55
Hide quick links:
Advertisement
Table of Contents
