How To Implement Object Tracking; Tracking The Line Protocol State Of An Interface - Cisco NCS 5000 Series Manual
System management configuration guide for cisco ncs 5000 series
routers
Hide thumbs
Also See for NCS 5000 Series:
- Hardware installation manual (72 pages) ,
- Manual (186 pages)
Table of Contents
Advertisement
How to Implement Object Tracking
• Boolean OR function—When the tracked list has been assigned a Boolean OR function, it means that
How to Implement Object Tracking
This section describes the various object tracking procedures.
Tracking the Line Protocol State of an Interface
Perform this task in global configuration mode to track the line protocol state of an interface.
A tracked object is considered up when a line protocol of the interface is up.
After configuring the tracked object, you may associate the interface whose state should be tracked and specify
the number of seconds to wait before the tracking object polls the interface for its state.
SUMMARY STEPS
1. configure
2. track track-name
3. type line-protocol state
4. interface type interface-path-id
5. exit
6. (Optional) delay {up seconds|down seconds}
7. Use one of the following commands:
DETAILED STEPS
Command or Action
Step 1
configure
Step 2
track track-name
Example:
RP/0/RP0/CPU0:router(config)# track track1
Step 3
type line-protocol state
Example:
RP/0/RP0/CPU0:router(config-track)# type
line-protocol state
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
46
at least one object defined within a subset must also be in an up state, so that the tracked object can also
be in the up state.
• end
• commit
Purpose
Enters track configuration mode.
• track-name—Specifies a name for the object to be tracked.
Creates a track based on the line protocol of an interface.
Implementing Object Tracking
Hide quick links:
Advertisement
Table of Contents
