Cisco NCS 5000 Series Manual page 166
System management configuration guide for cisco ncs 5000 series
routers
Hide thumbs
Also See for NCS 5000 Series:
- Hardware installation manual (72 pages) ,
- Manual (186 pages)
Table of Contents
Advertisement
Disabling NTP Services on a Specific Interface
DETAILED STEPS
Command or Action
Step 1
configure
Step 2
ntp
Example:
RP/0/RP0/CPU0:router(config)# ntp
Step 3
Use one of the following commands:
• no interface type interface-path-id
• interface type interface-path-id disable
Example:
RP/0/RP0/CPU0:router(config-ntp)# no
interface pos 0/0/0/1
or
RP/0/RP0/CPU0:router(config-ntp)# interface
POS 0/0/0/1 disable
Step 4
Use one of the following commands:
• end
• commit
Example:
RP/0/RP0/CPU0:router(config-ntp)# end
or
RP/0/RP0/CPU0:router(config-ntp)# commit
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
156
Purpose
Enters NTP configuration mode.
Disables NTP services on the specified interface.
Saves configuration changes.
• When you issue the end command, the system prompts you
to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
◦ Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
◦ Entering no exits the configuration session and returns
the router to EXEC mode without committing the
configuration changes.
◦ Entering cancel leaves the router in the current
configuration session without exiting or committing the
configuration changes.
• Use the commit command to save the configuration changes
to the running configuration file and remain within the
configuration session.
Implementing NTP
Hide quick links:
Advertisement
Table of Contents
