Dimension Drawing Of Test Probe For Measurement Tap - Siemens Simatic S7-1500/ET 200MP System Manual
Automation system
Hide thumbs
Also See for Simatic S7-1500/ET 200MP:
- System manual (385 pages) ,
- Compact operating instructions (129 pages) ,
- Manual (100 pages)
Table of Contents
Advertisement
Dimension drawings
A.9 Dimension drawing of test probe for measurement tap
A.9
Dimension drawing of test probe for measurement tap
To perform measurements on the front connector of the S7-1500/ET 200MP automation
system, you need a test probe with the following properties:
● Maximum diameter at measuring tip: 1 mm
● Length of measuring tip: ≥ 10 mm
Figure A-15
Corresponding test probes are available from electrical retailers.
334
Dimension drawing of test probe for measurement tap
Automation system
System Manual, 12/2017, A5E03461182-AE
Hide quick links:
Advertisement
Table of Contents
