Connecting The Cpu/Interface Module To The Load Current Supply - Siemens Simatic S7-1500/ET 200MP System Manual
Automation system
Hide thumbs
Also See for Simatic S7-1500/ET 200MP:
- System manual (385 pages) ,
- Compact operating instructions (129 pages) ,
- Manual (100 pages)
Table of Contents
Advertisement
Wiring
6.8 Connecting the CPU/interface module to the load current supply
Reference
Additional information about connecting the 24 V DC output voltage of the load voltage
supply modules is available in the manuals of the corresponding modules.
6.8
Connecting the CPU/interface module to the load current supply
Introduction
The load current supply is equipped with a plug-in 24 V DC output terminal (behind the front
cover at the bottom). You connect the wires for the supply voltage of the CPU/interface
module to this terminal.
Requirements
● Only wire the connection plug when the supply voltage is turned off.
● The connection plug for connecting the supply voltage to the CPU / interface module is
already mounted, see section Connecting the supply voltage (Page 139)).
Tools required
3 to 3.5 mm screwdriver
142
Automation system
System Manual, 12/2017, A5E03461182-AE
Hide quick links:
Advertisement
Table of Contents
