Real Axis In Ccd Master And Ccd Slave Move Synchronously To Measuring Encoder Position In Ccd Slave - Bosch REXROTH IndraDrive Applications Manual
Hide thumbs
Also See for REXROTH IndraDrive:
- Project planning manual (128 pages) ,
- Troubleshooting manual (437 pages) ,
- Instruction manual (26 pages)
Table of Contents
Advertisement
DOK-INDRV*-MLD-APPLI**-AW02-EN-P
Rexroth IndraDrive Rexroth IndraMotion MLD Application Examples
7.5.3
Real Axis in CCD Master and CCD Slave Move Synchronously to
Measuring Encoder Position in CCD Slave
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Synchronous Multi-Axis Motion With Virtual Master Axis
Real Axis in CCD Master and CCD Slave Move Synchronously to Measuring
Encoder Position in CCD Master
Example
Two axes are to move phase-synchronously to the measuring encoder position
of the CCD master axis.
Parameterization
Parameterization must be made in the CCD master axis.
Master axis format converter CCD dead time compensation (extrapolator)
P‑0‑0916, Master axis format
converter signal selection
P‑0‑0052
The parameter "P‑0‑0750, Master axis revolutions per master axis
cycle" for all axes has to be set to the value of the parameter
"P‑0‑0765, Modulo factor measuring encoder" of the CCD master
axis.
Programming
The operation mode "phase synchronization" is activated via the function block
"MB_GearInPos".
MB_GearInPos
Declaration
fbGearInPosAxis1: MB_GearInPos;
Task
Activation and parameterization of the operation mode "phase syn‐
chronization" in the CCD master axis.
Slave
Axis 1 (with MLD-M, always corresponds to CCD master axis and with
MLD-S, always corresponds to local axis)
Master
VmAxisExt (specification of master axis in the parameter "P‑0‑0053,
Master axis position")
MB_GearInPos
Declaration
fbGearInPosAxis2: MB_GearInPos;
Task
Activation and parameterization of the operation mode "phase syn‐
chronization" in the CCD slave axis.
Slave
Axis2 (corresponds to CCD slave axis → first CCD slave axis in CCD
axis group)
Master
VmAxisExt (specification of master axis in the parameter "P‑0‑0053,
Master axis position")
Example
Two axes are to move phase-synchronously to the measuring encoder position
of the CCD slave axis.
Parameterization
Bosch Rexroth AG
P‑0‑1616, CCD: Extrapo‐
P‑0‑1617, CCD: Number
lated cmd value signal se‐
of extrapolation steps
lection
P‑0‑0761
2
73/97
Hide quick links:
Advertisement
Table of Contents
