Table of Contents
Advertisement
SmartAX MA5612 Multi-service Access Module
Maintenance Guide
A.3.4 Attaching Labels
After printing or writing the label on the base page, remove the label from the base page, and
then attach the label to the cable or the identification plate of the cable tie. The following
describes how to attach the label for the signal cable and the power cable.
Attaching the Label to the Signal Cable
Attach the label to the signal cable, 2 cm away from the connector. In special cases, for example,
to avoid bending the cable or affecting other cables, attach the label at a different position on
the cable.
The labels should be attached to both ends of a cable. When the cable is placed vertically, the
label should point towards the right. When the cable is placed horizontally, the label should point
downwards.
Figure A-52 Attaching the label to the signal cable at a proper position
Figure A-53
Issue 01 (2012-07-25)
Figure A-52
shows how to attach the label to the signal cable at a proper position.
TO:
1
A01 2
A
06
shows how to attach the label to the signal cable.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
A Appendix
301
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
