ABB ACS880-07 Series Hardware Manual page 187
Industrial drives
Hide thumbs
Also See for ACS880-07 Series:
- Hardware manual (344 pages) ,
- User manual (74 pages) ,
- Firmware instructions (664 pages)
Table of Contents
Advertisement
1. Stop the drive and do the steps in section
you start the work.
2. Unplug quick connector(s) at the right top corner of the control unit mounting plate.
3. Remove the control unit mounting plate.
4. Remove the shroud.
5. Remove the air baffle.
6. Disconnect the drive module input busbars. Combi screw M12, 70 N·m (52 lbf·ft).
7. Disconnect the drive module output busbars. Combi screw M12, 70 N·m (52 lbf·ft).
8. Undo the screws that fasten the drive module to the cabinet at the top and behind the
front support legs.
9. Attach the extraction ramp to the cabinet base with two screws.
10. Attach the drive module lifting lugs to the cabinet lifting lug with chains.
11. Pull the drive module carefully out of the cabinet preferably with help from another person.
12. Install the new module in reverse order.
1
2
Electrical safety precautions (page 18)
Maintenance 187
1
2
before
Advertisement
Table of Contents
