Husqvarna K 1260 Workshop Manual page 45
Hide thumbs
Also See for K 1260:
- Operator's manual (32 pages) ,
- Price list (48 pages) ,
- Operator's manual (28 pages)
Table of Contents
Advertisement
16
1-4-
3-6-
1
4
45
CUTTING HEAD
Assembly – blade
guard/bearing housing
Make sure the rubber seal has
the right fit.
Turn the bearing housing so
that the screw holes are accessi-
ble.
Fit the blade guard – tigh-
ten the screws alternately
2-5-
Fit the seal ring
2
5
3
6
Assembly – blade guard
/bearing housing
Make sure the rubber seal has the right
fit in relation to the bearing housing and
blade guard.
Turn the bearing housing so that the
screw holes are accessible from above
with the tool.
Fit the blade guard – tighten the
screws alternately
The soft rubber ring under the washer is
pressed together when the plate washer is
fitted. The three screws must then be tigh-
tened alternately to avoid deforming the
plate washer.
Fit the seal ring
Press the seal ring fully down onto the
plate washer. The axle bushing has slots
for the seal ring that ensures secure en -
gagement when the seal is in the right
position.
Centre bush
Fit as follows:
1. Position the inner flange washer.
2. Position the centre bush.
3. Fit the screw for the blade's attach-
ment.
4. Press down the bush until the screw
bottoms.
5. Dismantle the screw and place it on
the other flange washer "turned the
wrong way". Refit the screw and press
down the bush against the inner flange
washer.
6. The bush is fitted.
Hide quick links:
Advertisement
Table of Contents
