Husqvarna K 1260 Workshop Manual page 51

Hide thumbs Also See for K 1260:

Table of Contents

HANDLE

Throttle lock

Press in the throttle in the handle top. Press the throttle

forwards with a screwdriver and lift up the rear edge.

Pull the throttle from the handle.

Removed throttle lock.

Important

If the white lever for the throttle wire is not included, as

shown below, it can be pressed with a screwdriver as shown

in the adjacent pictures. (The picture to the right shows a

divided handle.)

Throttle

Pull up the throttle until it stops.

Raise the white lever for the throttle wire and place it in the

position shown.

Press the unit at a slight angle to the side, as shown, and at

the same time work out the handle. Relatively strong force

is needed.

Removed throttle.

Installing the throttle

1. Fit the throttle wire to the throttle.

2. Put the throttle in place with the white lever up. Slide the

unit in a little.

3. Fold in the white lever in the notch on the throttle.

4. Press the unit completely in position for fitting of the

shaft.

Table of Contents

Show Quick Links

Table of Contents