Table of Contents
Advertisement
1. Module retaining screw 11 Eject Request: eject request button for a slot0 device
2. Active: supervisor redundancy status LED
3. PWR MGMT: system power status LED
4. ACT: management port packet activity LED
5. Link: management port link status LED
6. ACT: management port packet activity LED
7. Eject Request: eject request button for USB3 device
8. USB3: usb3 status LED 18 MGMT Ethernet0: MGMT0 Ethernet out of band management port.
9. USB Slot 0: USB ports 19 Console Serial Port: module RS232 serial console port
10. USB Slot0: slot0 status LED
11. Eject Request: eject request button for slot0 device
12. Reset: module reset button
13. Module lock release button
14. Status: system diagnostic test status LED
15. ID: locator LED
16. System: system environment status LED
17. MGMT Ethernet1: MGMT1 Ethernet out of band management port
18. MGMT Ethernet 0: MGMT0 Ethernet out of band management port
19. Console Serial Port: module RS232 serial console port
20. USB Slot 1: USB port
Table 3 on page 14 describes the LEDs on the IBM c-type SAN switches and directors Supervisor-4
Module.
Table 3. IBM Supervisor-4 Module LEDs
LED
ID
Status
14 IBM Storage Networking SAN192C-6, SAN384C-6 and SAN768C-6: SAN192C-6, SAN384C-6 and
SAN768C-6 Installation, Service, and User Guide
Status
Flashing blue
Off
Green
Red
Description
A user has activated this LED
to allow a person to find this
module in the chassis.
Location identification is
deactivated for this module.
All module diagnostics passed.
The module is operational.
The module has detected an
error and cannot power on or
boot up.
The module is not properly
inserted.
A bootup or runtime diagnostic
test has failed.
Advertisement
Table of Contents
