Table of Contents
Advertisement
4-6.
DPR Assembly
Preparation
1.
Remove the inside panel assembly. (Refer to
Procedure
1.
Remove the screw, and remove the front partition bracket.
Groove
Hole
PSW2 x 5
Hole
Front partition bracket
Note
When installing the front partition bracket, pay attention as follows.
• Align the three bosses with the two holes and the groove of the front partition bracket.
• Pass the five harnesses into the two notches A and B of the separator cushion (F) as shown below.
Notch A
Separator
cushion (F)
Notch B
HXC-FB75H/HXC-FB75KC
"4-4-1. Inside Panel
Assembly")
Bosses
Boss
Harnesses
Notch A
Notch B
Harnesses
4-18
Advertisement
Table of Contents
