Power Requirements; Power Connection Guidelines For Ac-Powered Systems - Cisco 6503 - Catalyst Firewall Security Sys Installation Manual
Installation guide
Hide thumbs
Also See for 6503 - Catalyst Firewall Security Sys:
- White paper (19 pages) ,
- Product bulletin (6 pages) ,
- Supplementary manual (3 pages)
Table of Contents
Advertisement
Power Requirements
Power Requirements
When preparing your site for the switch installation, follow these requirements:
•
•
•
•
•
•
•
•
Power Connection Guidelines for AC-Powered Systems
This section provides the basic guidelines for connecting the Catalyst 6500 series switch AC power
supplies to the site power source:
•
•
Catalyst 6500 Series Switches Installation Guide
2-22
In systems configured with two power supplies, connect each of the two power supplies to a separate
input power source. If you fail to do this, your system might be susceptible to total power failure
due to a fault in the external wiring or a tripped circuit breaker.
To prevent a loss of input power, be sure that the total maximum load on each source circuit is within
the current ratings of the wiring and breakers.
In some systems, you may decide to use an uninterruptible power supply (UPS) to protect against
power failures at your site. Be aware when selecting a UPS that some UPS models that use
ferroresonant technology can become unstable when operating with the Catalyst 6500 series switch
power supplies which use power factor correction (PFC). This can cause the output voltage
waveform to the switch to become distorted resulting in an undervoltage situation in the system.
The AC-input power supply has a detachable power cord (except for the 4000 W power supplies)
that allows you to connect each power supply to the site power source. The 4000 W AC-input power
supply power cords are hard-wired to the power supply and cannot be removed.
You can connect the DC-input power supply to the power source with heavy-gauge wiring connected
to a terminal block. The wire gauge size is determined by local electrical codes and restrictions.
If you are using a 200/240 VAC power source in North America, the circuit must be protected by a
two-pole circuit breaker.
The source AC outlet must be within 6 feet (1.8 meters) of the system and should be easily
accessible.
The AC power receptacles used to plug in the chassis must be the grounding type. The grounding
conductors that connect to the receptacles should connect to protective earth ground at the service
equipment.
Each chassis power supply should have a separate, dedicated branch circuit.
For North America:
The 950 W power supply requires a 15 A circuit.
–
The 1000 W power supply requires a 15 A or 20 A circuit.
–
The 1300 W, 1400 W, 2500 W, 2700 W, and 3000 W power supplies require a 20 A circuit.
–
The 4000 W power supply requires a 30 A circuit.
–
The 6000 W power supply requires one or two 20 A circuits.
–
–
The 8700 W power supply requires one, two, or three 20 A circuits.
Chapter 2
Preparing for Installation
OL-5781-08
Advertisement
Table of Contents
Troubleshooting
