Required Tools; Removing The Ac-Input Pem - Cisco 6503 - Catalyst Firewall Security Sys Installation Manual
Installation guide
Hide thumbs
Also See for 6503 - Catalyst Firewall Security Sys:
- White paper (19 pages) ,
- Product bulletin (6 pages) ,
- Supplementary manual (3 pages)
Table of Contents
Advertisement
Removing and Installing PEMs
Figure 4-56
Power supply 2
Power supply 1
Required Tools
Use a flat-blade or number 2 Phillips-head screwdriver to perform these procedures. Additionally, wire
cutters may be necessary to cut cable tie wraps.
Removing the AC-Input PEM
To remove an AC-input PEM, follow these steps:
Turn the power switch to the off (0) position on the PEM that you are removing. (See
Step 1
Disconnect the power cord from the power source. Do not touch the metal prongs on the power cord
Step 2
when it is still connected to the PEM.
Remove the power cord from the power connection on the PEM. Do not touch the metal prongs
Step 3
embedded in the PEM.
Step 4
Loosen the two captive installation screws. (See
Grasp the PEM with one hand, and slide it part of the way out of the chassis. Place your other hand
Step 5
underneath the PEM, as shown in
Step 6
If the PEM bay is to remain empty, install a blank PEM filler plate (Cisco part number 800-16719-01)
over the opening, and secure it with the captive installation screws.
Catalyst 6500 Series Switches Installation Guide
4-76
Catalyst 6503 Switch—Power Supply Location
(redundant)
Figure
4-57.)
Figure
4-58, and slide it completely out of the chassis.
Chapter 4
Removal and Replacement Procedures
Figure
4-55.)
OL-5781-08
Advertisement
Table of Contents
Troubleshooting
