Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 184
Installation guide
Hide thumbs
Also See for 6503 - Catalyst Firewall Security Sys:
- White paper (19 pages) ,
- Product bulletin (6 pages) ,
- Supplementary manual (3 pages)
Table of Contents
Advertisement
Attaching the Interface Cables
Table 3-5
Installing Supervisor Engine Uplink Ports (continued)
Supervisor Engine
Supervisor Engine 720
Supervisor Engine 720-10GE
Installing and Cabling GBIC Transceiver Uplink Ports
We strongly recommend that you do not install or remove the GBIC transceiver module with fiber-optic
Caution
cables attached to it because of the potential damage to the cables, the cable connector, or the optical
interfaces in the SFP transceiver. Disconnect all cables before removing or installing an SFP transceiver.
Removing and installing an GBIC transceiver can shorten its useful life. Do not remove and insert GBIC
Caution
transceivers more often than is absolutely necessary.
The GBIC transceiver modules are static-sensitive devices. Always use an ESD wrist strap or a similar
Caution
individual grounding device when handling GBIC transceivers or coming in contact with modules.
To install and cable an GBIC transceiver uplink port, follow these steps (see
Attach an ESD-preventive wrist strap to your wrist and to the ESD ground connector or a bare metal
Step 1
surface on your chassis.
Remove the GBIC transceiver from its protective packaging.
Step 2
Note
Check the label on the GBIC transceiver body to verify that you have the correct model for your network.
Step 3
Find the transmit (TX) and receive (RX) markings that identify the top side of the GBIC transceiver.
Step 4
Catalyst 6500 Series Switches Installation Guide
3-64
Uplink Port
Three uplink ports. Two ports require 1000BASE-X GBIC
transceivers be installed. One port is a 10/100/1000 port
with an RJ-45 connector.
Five uplink ports. Two ports require SFP transceivers be
installed. One port is a 10/100/1000 port with an RJ-45
connector. Two ports require that 10GBASE X2
transceivers be installed.
Do not remove the optical bore dust plugs until you are directed to do so later in the procedure.
Chapter 3
Installing the Switch
Procedures
"Installing and Cabling
GBIC Transceiver Uplink
Ports" section on
page 3-64
"Installing and Cabling
Optical SFP Transceiver
Uplink Ports" section on
page 3-66
"Installing and Cabling
Copper SFP Transceiver
Uplink Ports" section on
page 3-68
"Installing and Cabling
10GBASE-X X2
Transceiver Uplink Ports"
section on page 3-73
Figure
3-35):
OL-5781-08
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Cisco 6503 - Catalyst Firewall Security Sys
Related Products for Cisco 6503 - Catalyst Firewall Security Sys
- Cisco 6503-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6504-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6506 - Catalyst Chassis Switch
- Cisco 6513 - Catalyst Switch
- Cisco Catalyst 6509
- Cisco Catalyst 6513-E
- Cisco Catalyst 6500-E Series
- Cisco CATALYST 6500 WS-X6066-SLB-S-K9