Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 268
Installation guide
Hide thumbs
Also See for 6503 - Catalyst Firewall Security Sys:
- White paper (19 pages) ,
- Product bulletin (6 pages) ,
- Supplementary manual (3 pages)
Table of Contents
Advertisement
Removing and Installing the DC-Input Power Supplies
If you are not going to remove the IPM, skip steps 7 and 8 and go to step 9.
Note
Loosen the IPM captive installation screws on the power supply. See
Step 7
Lift up on both IPM latches and remove the IPM. See
Step 8
Figure 4-43
Step 9
Loosen the captive installation screw on the power supply
Caution
Use both hands to install and remove power supplies. Each DC-input power supply weighs 35 pounds
(16 kg).
Grasp the power supply handle with one hand and slide the power supply part of the way out of the
Step 10
chassis. Place your other hand underneath the power supply, as shown in
in
Figure 4-45
If the power supply bay is to remain empty, install a blank power supply filler plate (Cisco part number
Note
700-03104-01) over the opening, and secure it with the captive installation screws.
Catalyst 6500 Series Switches Installation Guide
4-62
Removing the IPM Module
CI SC O SY
ST EM S, IN
C
1
2
3
IN PU T
OK
(with IPM), and slide the power supply completely out of the chassis.
Chapter 4
Figure
4-43.
4
FA N
OU TP UT
OK
FA IL
(Figure
4-41).
Removal and Replacement Procedures
Figure
4-41.
Figure 4-44
(without IPM) and
OL-5781-08
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Cisco 6503 - Catalyst Firewall Security Sys
Related Products for Cisco 6503 - Catalyst Firewall Security Sys
- Cisco 6503-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6504-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6506 - Catalyst Chassis Switch
- Cisco 6513 - Catalyst Switch
- Cisco Catalyst 6509
- Cisco Catalyst 6513-E
- Cisco Catalyst 6500-E Series
- Cisco CATALYST 6500 WS-X6066-SLB-S-K9