Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 34
Installation guide
Hide thumbs
Also See for 6503 - Catalyst Firewall Security Sys:
- White paper (19 pages) ,
- Product bulletin (6 pages) ,
- Supplementary manual (3 pages)
Table of Contents
Advertisement
Catalyst 6504-E Switch
Table 1-5
Table 1-5
Catalyst 6504-E Switch Features
Feature
Chassis
Supervisor engine
Modules
Backplane bandwidth
Catalyst 6500 Series Switches Installation Guide
1-14
lists the features of the Catalyst 6504-E switch chassis.
Description
•
Four horizontal slots. Slots are numbered from 1 (top) to 4 (bottom).
Supports Supervisor Engine 2, Supervisor Engine 32, Supervisor
•
Engine 32 PISA, Supervisor Engine 720, and Supervisor
Engine 720-10GE.
Note
Refer to your software release notes for the minimum software
release versions required to support the supervisor engines.
•
Supervisor engines are installed in slot 1 and slot 2.
Slots not occupied by supervisor engines can be used for modules.
Note
Check your software release notes for any restrictions on the type of
module that can be installed.
•
Supervisor Engine 720, Supervisor Engine 720-10GE, and Supervisor
Engine 2T have a built-in switching fabric. Switch Fabric Modules
(WS-C6500-SFM and WS-X6500-SFM2) are not supported.
Supervisor Engine 32 and Supervisor Engine 32 PISA do not support
•
the Switch Fabric Modules (WS-C6500-SFM and WS-X6500-SFM2).
The uplink ports are fully functional on the redundant supervisor engine
•
when it is in standby mode.
In systems with redundant supervisor engines, both supervisor
Note
engines must be the same model and have the same daughter card
configurations. Each supervisor engine must have the resources to
run the switch on its own, which means that all supervisor engine
resources are duplicated. Identical supervisor engine memory
configurations are recommended, but are not required as long as the
supervisor engine with the smaller memory configuration is
sufficient to run the configured features of the switch. Additionally,
each supervisor engine must have its own flash device and console
port connections.
Supports up to three Catalyst 6500 series modules.
•
Does not support the WS-C6500-SFM and WS-X6500-SFM2 Switch
•
Fabric Modules.
Some Catalyst 6500 series modules may:
•
Not be supported or have slot restrictions
–
Require that you install a Supervisor Engine 720
–
Require a specific software release level to operate
–
Check your software release notes for specific information.
Note
32 GBps shared bus.
•
720 GBps switch fabric.
•
Chapter 1
Product Overview
OL-5781-08
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Cisco 6503 - Catalyst Firewall Security Sys
Related Products for Cisco 6503 - Catalyst Firewall Security Sys
- Cisco 6503-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6504-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6506 - Catalyst Chassis Switch
- Cisco 6513 - Catalyst Switch
- Cisco Catalyst 6509
- Cisco Catalyst 6513-E
- Cisco Catalyst 6500-E Series
- Cisco CATALYST 6500 WS-X6066-SLB-S-K9