Cisco IE-3000-8TC Command Reference Manual page 37

Command reference

Hide thumbs Also See for IE-3000-8TC:

Table of Contents

IE 3000 Switch Cisco IOS Commands

AlarmList ID Alarm Description

After you have created an alarm profile, you can attach the profile to an interface by using the

alarm-profile interface configuration command.

By default, the defaultPort profile is applied to all interfaces. This profile enables only the Port Not

Operating (3) alarm. You can modify this profile by using the alarm profile defaultPort global

configuration command to enter alarm profile configuration mode for this profile.

This example shows how to create the alarm profile fastE for a port with the link-down (alarm 1) and

port not forwarding (alarm 2) alarms enabled. The link-down alarm is connected to the minor relay

circuitry, and the port not forwarding alarm is connected to the major relay circuitry. These alarms are

sent to an SNMP server and written to the system log file (syslog).

Switch(config)# alarm profile fastE

Switch(config-alarm-prof)# alarm 1 2

Switch(config-alarm-prof)# relay major 2

Switch(config-alarm-prof)# relay minor 1

Switch(config-alarm-prof)# notifies 1 2

Switch(config-alarm-prof)# syslog 1 2

This example shows how to delete the alarm relay profile named my-profile:

Switch(config)# no alarm profile my-profile

Related Commands

alarm profile (interface

configuration)

show alarm profile

snmp-server enable traps

AlarmList ID Numbers and Alarm Descriptions

Port not Forwarding.

Port not Operating.

FCS Error Rate exceeds threshold.

Attaches an alarm profile to an interface.

Displays all alarm profiles or a specified alarm profile and lists the

interfaces to which each profile is attached.

Enables the switch to send SNMP notification for various trap types

to the network management system (NMS).

alarm profile (global configuration)

Cisco IE 3000 Switch Command Reference