Guidelines For Particulate Matter - Cisco Catalyst 2960 Hardware Installation Manual

Hide thumbs Also See for Catalyst 2960:

Configuration manual (2288 pages)

Software configuration manual (980 pages)

Command reference manual (800 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

Table of Contents

Preparing for Installation

This unit might have more than one power supply connection. All connections must be removed to

Warning

de-energize the unit. Statement 1028

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Warning

Statement 1030

Warning

Ultimate disposal of this product should be handled according to all national laws and regulations.

Statement 1040.

Warning

For connections outside the building where the equipment is installed, the following ports must be

connected through an approved network termination unit with integral circuit protection: 10/100/1000

Ethernet. Statement 1044

When installing or replacing the unit, the ground connection must always be made first and

Warning

disconnected last. Statement 1046

Voltages that present a shock hazard may exist on Power over Ethernet (PoE) circuits if

Warning

interconnections are made using uninsulated exposed metal contacts, conductors, or terminals.

Avoid using such interconnection methods, unless the exposed metal parts are located within a

restricted access location and users and service people who are authorized within the restricted

access location are made aware of the hazard. A restricted access area can be accessed only through

the use of a special tool, lock and key or other means of security. Statement 1072

No user-serviceable parts inside. Do not open. Statement 1073

Warning

Installation of the equipment must comply with local and national electrical codes. Statement 1074

Warning