hit counter script

Connecting To Fiber-Optic Sfp Modules - Cisco Catalyst 2960 Hardware Installation Manual

Hide thumbs Also See for Catalyst 2960:
Table of Contents

Advertisement

Connecting to SFP Modules

Connecting to Fiber-Optic SFP Modules

Follow these steps to connect a fiber-optic cable to an SFP module:
Class 1 laser product. Statement 1008
Warning
Caution
Do not remove the rubber plugs from the SFP module port or the rubber caps from the fiber-optic cable
until you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables
from contamination and ambient light.
Before connecting to the SFP module, be sure that you understand the port and cabling stipulations in
the
See
module.
Step 1
Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use.
Insert one end of the fiber-optic cable into the SFP module port (see
Step 2
Figure 2-17
1
Insert the other cable end into a fiber-optic receptacle on a target device.
Step 3
Observe the port status LED.
Step 4
The LED turns green when the switch and the target device have an established link.
The LED turns amber while the STP discovers the network topology and searches for loops. This process
takes about 30 seconds, and then the port LED turns green.
If the LED is off, the target device might not be turned on, there might be a cable problem, or there might
be problem with the adapter installed in the target device. See
solutions to cabling problems.
If necessary, reconfigure and restart the switch or target device.
Step 5
Catalyst 2960 Switch Hardware Installation Guide
2-20
"Installation Guidelines" section on page 2-5
Appendix A, "Connector and Cable Specifications"
Connecting to a Fiber-Optic SFP Module Port
1
LC connector
Chapter 2
Switch Installation (24- and 48-Port Switches)
and in the
"SFP Module Slots" section on page
for information about the LC on the SFP
Figure
Chapter 4, "Troubleshooting,"
1-10.
2-17).
for
OL-7075-05

Advertisement

Table of Contents
loading

Table of Contents