Installation Guidelines - Cisco Catalyst 2960 Hardware Installation Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages)
Table of Contents
Advertisement
Chapter 3
Switch Installation (8-Port Switches)
Class 1 laser product. Statement 1008
Warning
The plug-socket combination must be accessible at all times, because it serves as the main
Warning
disconnecting device. Statement 1019
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040.
For connections outside the building where the equipment is installed, the following ports must be
Warning
connected through an approved network termination unit with integral circuit protection: 10/100/1000
Ethernet. Statement 1044
When installing or replacing the unit, the ground connection must always be made first and
Warning
disconnected last. Statement 1046
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Installation Guidelines
This section is specific to the Catalyst 2960 8-port switches. For information applicable to the other
Catalyst 2960 switches, see
When you determine where to place the switch, be sure to observe these requirements:
•
•
•
OL-7075-05
Chapter 2, "Switch Installation (24- and 48-Port Switches)."
The operating environment must be within the ranges listed in
Specifications."
Airflow around the switch and through the vents must be unrestricted.
We strongly recommend that you allow at least 3 inches (7.6 cm) of clearance around the ventilation
openings.
Temperature around the unit does not exceed 113°F (45°C).
If the switch is installed in a closed environment or in a multirack assembly, the temperature around
it might be greater than normal room temperature.
Appendix B, "Technical
Catalyst 2960 Switch Hardware Installation Guide
Preparing for Installation
3-3
Advertisement
Table of Contents
