Switchport Customer Vlan - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
56
1069
Syntax
switchport general acceptable-frame-type {tagged-only | untagged-only | all}
no switchport general acceptable-frame-type
Parameters
•
tagged-only—Ignore (discard) untagged packets and priority-tagged
packets.
•
untagged-only—Ignore (discard) VLAN-tagged packets (not including
priority-tagged packets)
•
all—Do not discard packets untagged or priority-tagged packets.
Default Configuration
All frame types are accepted at ingress (all).
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example configures port gi 1 3 to be in general mode and to discard
untagged frames at ingress.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
56.20 switchport customer vlan
Use the switchport customer vlan Interface Configuration mode command to set
the port's VLAN when the interface is in customer mode (set by the switchport
mode command). Use the no form of this command to restore the default
configuration.
Syntax
switchport customer vlan
no switchport customer vlan
Virtual Local Area Network (VLAN) Commands
interface gi13
switchport mode general
switchport general acceptable-frame-type tagged-only
vlan-id
OL-32830-01 Command Line Interface Reference Guide
Advertisement
Table of Contents
