Show Ipv6 Route - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
IPv6 Commands
OL-32830-01 Command Line Interface Reference Guide
IPv6 Address
2000:0:0:4::2
Field Descriptions:
•
Total number of entries—Number of entries (peers) in the cache.
•
IPv6 Address—IPv6 address of neighbor or interface.
•
Age—Time (in minutes) since the address was confirmed to be reachable. A
hyphen (-) indicates a static entry.
•
Link-layer Addr—MAC address. If the address is unknown, a hyphen (-) is
displayed.
•
Interface—Interface which the neighbor is connected to.
•
Router—Specifies if the neighbor is a Router. A hyphen (-) is displayed for
static entries.
27.16 show ipv6 route
Use the show ipv6 route command in user EXEC or privileged EXEC mode to
display the current contents of the IPv6 routing table.
Syntax
ipv6-address
show ipv6 route [
interface-id
]
Parameters
•
ipv6-address
—Displays routing information for a specific IPv6 address.
This argument must be in the form documented in RFC4293 where the
address is specified in hexadecimal using 16-bit values between colons.
•
ipv6-prefix
—Displays routing information for a specific IPv6 network. This
argument must be in the form documented in RFC4293 where the address
is specified in hexadecimal using 16-bit values between colons.
•
prefix-length
/
—The length of the IPv6 prefix. A decimal value that indicates
how many of the high-order contiguous bits of the address comprise the
prefix (the network portion of the address). A slash mark must precede the
decimal value.
Age Link-layer Addr
0
0003.a0d6.141e
ipv6-prefix/prefix-length
|
State
Interface Router
REACH
VLAN1
Yes
protocol
|
| interface
27
630
Advertisement
Table of Contents
