Bridge Multicast Ipv6 Source Group - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Address Table Commands
OL-32830-01 Command Line Interface Reference Guide
•
interface-list
ethernet
Separate nonconsecutive Ethernet ports with a comma and no spaces. Use
a hyphen to designate a range of ports.
•
port-channel-list
port-channel
Separate nonconsecutive port-channels with a comma and no spaces. Use
a hyphen to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Before defining forbidden ports, the Multicast group should be registered.
You can execute the command before the VLAN is created.
Example
The following example registers an IPv6 Multicast address, and forbids the IPv6
address on port gi 1 4 within VLAN 8.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
FF00:0:0:0:4:4:4:1 add gi14
5.12
bridge multicast ipv6 source group
To register a source IPv6 address - Multicast IPv6 address pair to the bridge table,
and statically add or remove ports to or from the source-group, use the bridge
multicast ipv6 source group Interface (VLAN) Configuration mode command. To
unregister the source-group-pair, use the no form of this command.
—(Optional) Specifies a list of Ethernet ports.
—(Optional) Specifies a list of port channels.
interface vlan 8
bridge multicast ipv6 ip-address FF00:0:0:0:4:4:4:1
bridge multicast ipv6 forbidden ip-address
5
156
Advertisement
Table of Contents
