Dhcp Snooping Commands; Ip Dhcp Snooping - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
DHCP Snooping Commands
OL-32830-01 Command Line Interface Reference Guide
13.0
13.1
ip dhcp snooping
Use the ip dhcp snooping Global Configuration mode command to enable
Dynamic Host Configuration Protocol (DHCP) Snooping globally. Use the no form
of this command to restore the default configuration.
Syntax
ip dhcp snooping
no ip dhcp snooping
Parameters
N/A
Default Configuration
DHCP snooping is disabled.
Command Mode
Global Configuration mode
User Guidelines
For any DHCP Snooping configuration to take effect, DHCP Snooping must be
enabled globally. DHCP Snooping on a VLAN is not active until DHCP Snooping on
a VLAN is enabled by using the
command.
Example
The following example enables DHCP Snooping on the device.
switchxxxxxx(config)#
ip dhcp snooping vlan
ip dhcp snooping
13
Global Configuration mode
310
Advertisement
Table of Contents
