Ipv6 Icmp Error-Interval - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
27
613
Parameters
N/A
Default Configuration
IPv6 addressing is enabled.
Command Mode
Interface Configuration mode
User Guidelines
This command automatically configures an IPv6 link-local Unicast address on the
interface while also enabling the interface for IPv6 processing. The no ipv6 enable
command does not disable IPv6 processing on an interface that is configured with
an explicit IPv6 address.
Example
The following example enables VLAN 1 for the IPv6 addressing mode.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
27.8
ipv6 icmp error-interval
Use the ipv6 icmp error-interval command in Global Configuration mode to
configure the interval and bucket size for IPv6 ICMP error messages. To return the
interval to its default setting, use the no form of this command.
Syntax
ipv6 icmp error-interval
no ipv6 icmp error-interval
interface vlan 1
ipv6 enable
exit
milliseconds
bucketsize
[
OL-32830-01 Command Line Interface Reference Guide
IPv6 Commands
]
Advertisement
Table of Contents
