Cisco 300 Series Cli Manual page 631

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

protocol—Displays routes for the specified routing protocol using any of

these keywords: bgp, isis, ospf, or rip; or displays routes for the specified

type of route using any of these keywords: connected, static, nd, or icmp.

interface-id

Default Configuration

All IPv6 routing information for all active routing tables is displayed.

Command Mode

User EXEC mode

Privileged EXEC mode

User Guidelines

This command provides output similar to the show ip route command, except that

the information is IPv6-specific.

ipv6-address

longest match lookup is performed from the routing table and only route

information for that address or network is displayed. When the icmp, nd,

connected, local, or static keywords are specified, only that type of route is

displayed. When the

interface-specific routes are displayed.

Example 1. The following is sample output from the show ipv6 route command

when the command is entered without an IPv6 address or prefix specified:

switchxxxxxx#

show ipv6 route

Codes: > - Best

S - Static, I - ICMP Redirect, ND - Router Advertisment

[d/m]: d - route's distance, m - route's metric

IPv6 Routing Table - 6 entries

S> ::/0 [1/1]

via fe80::77

via fe80::200:cff:fe4a:dfa8 VLAN 1 Lifetime 1784 sec

—Identifier of an interface.

prefix-length

interface-id

argument are specified, only the specified

OL-32830-01 Command Line Interface Reference Guide

IPv6 Commands

argument is specified, a