Spanning-Tree Port-Priority - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
46
Spanning-Tree Commands
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example configures the spanning-tree cost on
15 to 35000.
gi1
switchxxxxxx(config)#
interface
gi1
15
switchxxxxxx(config-if)#
spanning-tree cost 35000
46.9 spanning-tree port-priority
Use the spanning-tree port-priority Interface (Ethernet, Port Channel)
Configuration mode command to configure the port priority. Use the no form of this
command to restore the default configuration.
Syntax
priority
spanning-tree port-priority
no spanning-tree port-priority
Parameters
priority—Specifies the port priority. (Range: 0–240)
Default Configuration
The default port priority is 128.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
The priority value must be a multiple of 16.
Example
The following example configures the spanning priority on
15 to 96
gi1
895
OL-32830-01 Command Line Interface Reference Guide
Advertisement
Table of Contents
